Navigation:  Microstation > Project Configuration > Bentley Building Products >

CAD File Structure

Previous pageReturn to chapter overviewNext page

A recommended file naming convention for use with Structural Modeller is as follows:

Filename

Purpose

Location

TM_*.dgn

The 3d model, broken down into areas of the building, usually by floor

{Project CAD files folder}\triforma_model\

TS_*.dgn

2d drawing extractions generated from the model

{Project CAD files folder}\triforma_sections\

 

CADtools Structural uses this folder structure to locate the default destination of the extracted drawings ( i.e. From the location of the 3d model, go up one directory, then back down one directory into triforma_sections and create extracted drawing there)

Eg.  2d extractions from a model in J:\123000\123456-00\4 Internal Project Data\4-03 Drawings\S_Structural\triforma_model\  will be placed in J:\123000\123456-00\4 Internal Project Data\4-03 Drawings\S_Structural\triforma_sections\

 

 

 

 


Direct link to this topic:

© 2013 Arup