Type: System file
Location:
CADplot can use multiple Substitution.ini files; see Configuration file locations and System file searching. The sub-folder used is:
…\CADplot\Engine
Description:
When naming plot files using the drawing title block attributes instead of the drawing filename (e.g. 345m001.dwg to M/001 RevA.plt) you must make sure that the plot file name does not contain any invalid characters such as a /.
The substitution.ini will replace any invalid characters found with an alternative. By default invalid characters will be replaced by an _ therefore the example above would become M_001 RevA.plt
Direct link to this topic:
© 2011 Arup